02-04-2015 07:23 PM
Hi all,
So I'm working on a VI that dislays sound pressure level.
From the other discussions, it says that SPL can't be measured unless you have a calibrated microphone and a known amplification path.
So basically LabVIEW has this SVL Calibrate Microphone (DAQmx) to calibrate the mic. However, I tried to use it but I've got no result.
I have an ECM 8000 condenser microphone and I'm using a USB-6215 DAQ.
How do I perform this calibration?
02-04-2015 09:56 PM
02-04-2015 10:09 PM
When I run the SVL Calibrate Microphone, there is no output from the calibrated sensor sensitivity?
How do I connect my micropone from the DAQ, do I select it as input or select as output. How do I calibrate it?
02-04-2015 10:09 PM
When I run the SVL Calibrate Microphone, there is no output from the calibrated sensor sensitivity?
How do I connect my micropone from the DAQ, do I select it as input or select as output. How do I calibrate it?
04-24-2016 10:16 AM
HI:
I'm doing the microphone sensitivity calibration vip, I have been given, what your problem solved?
04-25-2016 02:20 PM - edited 04-25-2016 02:23 PM
Hi,
I saw that you posted your question on an old thread. In order to get more visibility, I would suggest creating a new thread with your question to get more chances to have an answer. Our forum community is rather active and this will allow you to have a faster answer. Hope this helps!
Best Regards