I have recently upgraded to the newest version of all labview related software. I was going to install software onto my sbRIO-9636, but NI MAX will not show me the software drop down and so I can't add/remove programs to and from my sbRIO. I didn't have this problem with the previous version. Any help would be greatly appreciated.
Are you sure you installed the sbRIO drivers (might be part of the cRIO driver set)? That would be the obvious thing.
There are only two ways to tell somebody thanks: Kudos and Marked Solutions Unofficial Forum Rules and Guidelines "Not that we are sufficient in ourselves to claim anything as coming from us, but our sufficiency is from God" - 2 Corinthians 3:5
I have went through that and am already connected via crossover cable and have set up a static IP address. I tried to reset it and follow through the process again, but have come to the same result.
What are the IP settings of the sbRIO and the computer? I think they need to be on the same subnet.
There are only two ways to tell somebody thanks: Kudos and Marked Solutions Unofficial Forum Rules and Guidelines "Not that we are sufficient in ourselves to claim anything as coming from us, but our sufficiency is from God" - 2 Corinthians 3:5
The subnet settings are identical on both the rio and the computer. The IP address of the rio is the same as the computer except it ends in 33 while the computer ends in 34. I have the rio's gateway and dns server set to 0.0.0.0.
