Cannot terminate LabVIEW application

[Hemagopal]

Hello

I am using LabVIEW drivers for Pickering precision resistor card to set the resistance programatically.

I have attached the VI. I am able to set the resistance and the program does not give any errors. I am able to close manually the front panel and block diagram of the VI.

But I cannot close LabVIEW after that. LabVIEW hangs.Please let me know what can be the reason for this.

Regards

[Ranjeet_Singh]

Can you attach remaining VIs specially pipx40 close.vi

[.aCe. · Accepted solution]

I think your best bet is to fire an email off to pickering support, they are normally good at getting back to you.