Communication error USB7855R

[G-M]

Hello everyone,

I am now using the USB 7855R FPGA again after a longer break and I am getting an error about the communication between host computer and the FPGA target:

I am using the same LabView project as before, were everything was still working properly, and I can't find out what could be different. To answer the question from the error message, I am not using an external clock, only the internal one. I turned the device off, re-connected it, I was searching for some settings that I could change, but didn't find any and I created a new clock, all without success.

I would be very great full for any hints and pointers.

Cheers,

Gian-Marco

[Terry_ALE]

Can you try shipping examples and see if they work?

[G-M]

I followed the example described here:

https://knowledge.ni.com/KnowledgeArticleDetails?id=kA03q000000YHblCAG&l=en-CH

and I am getting the same error messages.

[Terry_ALE]

During the 'long break' did anything change on the computer?  I assume something has changed there in terms of its configuration, software that is installed, etc.

Since most/any example code is reporting the same errors it should be something more basic so to speak.

[G-M]

The last time I used it was last July where everything worked was last July. And as far as I remember there have been no substantial changes, apart from some Windows updates.