LabVIEW

Delay in For Loop

Hi,

I am using a For Loop for Setting some register (around 27) bits of a target board using CAN2.0 Extended Protocol. The implementation is working fine, but getting some unexpected delay (around 20 Sec). CAN Baud Rate is set as 500Kbps.

Anybody Please Comment on this.

Regards,

mfpktr

Message 1 of 2

(2,266 Views)

You should attach your code....

Norbert

Norbert
----------------------------------------------------------------------------------------------------
CEO: What exactly is stopping us from doing this?
Expert: Geometry
Marketing Manager: Just ignore it.