Failure to create rfnoc_graph

[kartiknattar]

I have a usrp x410. I am using LabVIEW 2022 with required drivers.

I have connected the USRP using ethernet and updated the usrp as per the installation guide and updated the mender file also.

When I run the async transmit example I get error stating "Failure to create rfnoc_graph".

I have searched the forum for the error code.

I found one https://forums.ni.com/t5/USRP-Software-Radio/USRP-X410-runtime-error-Graph-edge-list-is-empty-for-tx...

I tried the mentioned step as per the above link, but I am still getting error.

Below is the terminal error image.

 

Has anyone faced this issue before, if so then let me know how to resolve this error.

[JarrodR]

I have a USRP X410 as well. I am receiving the same error. I have updated FPGA image, and followed documentation for all steps. 

[ERROR] [LMX2572] Unable to communicate with LMX2572! Expected R125==0x2288, got: FFFF
[ERROR] [RFNOC::GRAPH] Error during initialization of block 0/Radio#0!
[ERROR] [RFNOC::GRAPH] Caught exception while initializing graph: RuntimeError: Unable to communicate to LMX2572!
Error: RuntimeError: Failure to create rfnoc_graph.

[ERROR] [LMX2572] Unable to communicate with LMX2572! Expected R125==0x2288, got: 0000
[ERROR] [RFNOC::GRAPH] Error during initialization of block 0/Radio#0!
[ERROR] [RFNOC::GRAPH] Caught exception while initializing graph: RuntimeError: Unable to communicate to LMX2572!
Error: RuntimeError: Failure to create rfnoc_graph.

Sometimes I receive different value for the R125 register on the LMX2572.

If anyone has any insight that would be greatly appreciated.