Hi, I need help with my Digital control unit wich is connected to a sensorDAQ card.
In my proyect I use 2 sensorDAQ cards, but only in one of them is connected the DCU, i run a program in wich i change the chanel of the digital control unit with a case structure, so if is true, then the ch of the DCU is changed to #14 for a set amount of time and then it must stop and dont turn on again, if it false it must leave the DCU in #ch 0.
My problem is that whenever it get any case (true or false) a window pop up and ask me in wich card is the DCU connected, this is the window I whant to avoid.
I find in the vernier digital instruments in the part of low level programing 2 modules, start and setup, I almost sure with this modules I can select that always run with a card.
So can it be done? If yes in wich way, if no, can you tell me why and help me find anotehr solution?
Thanks for your help.
