I2C test and programming with NI UXB-8451

[kawaiicat]

hi,

i want to ask how to see the waveform of 8451 with the example programming.

It is because i want to clarify if it is working and sending the right data to my slave.

actually i modify the program as i only want to send 255 set 1byte data to the I2C with some delay time
can i make use the general I2C write example? i find it is 0 at the read/write bit, so it is write or read? i am confuse when i saw the waveform once a while in the CRO but then i can never catch them again.

thanks

[Krista H]

Hi,

The output of the NI-845x I2C Write Read.vi is an array you could connect that array to a Graph or Chart to visually see it or you could use Build Waveform to build the array into a waveform data type.
As for the General I2C Write Example, currently it is only setup to Write but you could add the read functionality by adding a similar configuration to that of the General I2C Read example. Some more information about the you being able to see the waveform or what you are doing would be helpful.