Is there anything in particlar that I need other than the installation disk when upgrading from Labview 8 to 2010

[DougAM]

I have a Labview program that ran fine when I had Labview 8 installed. I recently upgraded to Labview 2010 and now my program will not work. When I run the program, none of my instruments read out and after about 5 seconds, the whole Labview program closes with no error messages. Can someone please help? I am a new Labview user and I don't really know how to troubleshoot this problem.

[aeastet]

If you have the installation disks that should be all you need. You will need a connection to the internet to register your product.

[Dennis_Knutson]

Did you install the hardware drivers after installing LabVIEW?

p.s. 2011 was just released. Might as well upgrade to that.