My code looks normal as it should, but when executing, it does not do the job!

[Prince2014]

Dear all,

Can anyone please help me with my problem?

I wrote a code for a Keithley 2200 DC power supplies. In one of the first steps of the program, current and voltage are measured, then it goes to next step. In this step I want to do the followings:

1- Set current (e.g. I= 100 mA) and read voltage

2- If the voltage fluctuations are less than 0.1V , Divide current by 2  ( I ---> I ÷ 2, e.g. I = 100÷2=50 mA)

3- Set new current  on 50 mA

4- Read voltage

5- Again, if the voltage fluctuations were less than 0.1V, Divide current by 2  (e.g. 50÷2= 25 mA)

6-Set new current on 25 mA

7-Read voltage

8- Continue this process until final voltage is reached (We determine the final voltage ourself)

I do not know if my program is working as I want! 

Please let me know if you can help.

Best regards.

[RavensFan]

Duplicate Post

[Prince2014]

Thanks for your consideration,

Sorry but I do not see your response! 

[camerond]

Then check the OTHER thread you started on this same topic.

Cameron