I am trying to use the RS-232 connection to receive input voltages from a circuit. I am not trying to read the byte type data. Each pin is to be connected to a device within the circuit that will give a voltage within the range of the RS-232, 3 to 15V. 2 of the pins will have a range of voltage values, analog sensors. 2-3 more pins will be digital sensors and 1 more pin will be the power on signal to LavVIEW. I need LabVIEW to read in these signals over a RS-232 connection port and cable and set a sampling rate for the 2 analog signal voltage pins. My thought on this was to have a VI that directly interfaced the port inputs instead of interfacing using the computer like the RS-232 example VIs that come with LabVIEW. But as I am a beginner I come asking for the advice of those with more experience.
