Dear friends and colleagues!
I have a question for working on Arduino with a LabVIEW program!
As I have used, there are two methods including LabVIEW Interface for Arduino and LINX.
Both of them can be installed from VIPM.
However, I am wondering about the working of collaborating between them.
For example, with LV Interface for arduino, we have to use Arduino IDE to compile LIFA base to a hex file, then embed it into Arduino as known as firmware or something like that. If this step is success, that mean we can use LabVIEW to program and talk to arduino according to RS232 protocol?
My questions are:
(1) the process that I shown above is right?
(2) For LINX, everything is running smooth and easier but is it same process with LabVIEW arduino Interface?
Many thanks!
