Reading custom UART message with a 16 bit termination character?

[smweil]

Hello,

I'm new to LabView and I'm trying to part a UART from a motor controller. I'm using the "continuous Serial Write and Read" vi provided, but I can't seem to get any useful messages displayed. The only documentation I have on the protocol is:

Baud rate: 115200

Index	Datapoint	Size
0	Voltage	16bit Unsigned Int
1	Temperature	16bit Unsigned Int
2	Bus Current	16bit Int
3	Reserved	16bit Unsigned Int
4	E-RPM	32bit Unsigned Int
5	Input Duty	16bit Unsigned Int
6	Motor Duty	16bit Unsigned Int
7	Status Flags	8bit Unsigned Int
8	Reserved	8bit Unsigned Int
9	Checksum (Fletcher)	16bit Unsigned Int
10	Stop Bytes	16bit (Value is 65535)

I have tried using the example with the correct baud rate, default data bits, parity and stop bits with the termination character set to 0xFF (from the C code attached). So far it's mostly gibberish, but I'm not sure how to break the data stream into the above packets...

Additionally I have some code written in C that is designed to parse the messages which I will attach. I was wondering if anyone could help me along my path to parsing these messages continuously to extract the data above. Thank you so much!