What type of circuits I can diesign on prototyping board interfacing with LabVIEW 8.5.1

[mahiii]

Hiiii...Everyone....

I mean to say that there wont be any physical equipment. I want to simulate that physical equipment in the labview i.e. virtually. In detail.... i have one

equipment for temperature process control with heat exchanger i have studied its characteristics and all........now i want to simulate r design that equipment

in labview.  Which is nothing but like virtual instrument. I want to design virtual instrument r equipment............

Thank you........

[JeffL]

Well, LabVIEW is a programming language, so you can pretty much do whatever you can think of. For the simulation aspects, perhaps you'd be interested in the Control Design and Simulation Module.

[mahiii]

Hi.... thank you for giving reply. I have used the control design and simulation for my problem....thank you

Now I have NI ELVIS prototyping board on which what type of circuits i can design so that it can interface with LabVIEW. Suggest any low power circuit as an example and is there any information regarding interface through DAQ system to the PC i mean that from the circuit outputs are given to DAQ then to PC(labview) how it will allocate for the perticular port is for perticular output ??

plzz give me information regarding above problem. or send me if any sample programs are there for this circuit design on prototyping board.

thank you....

[ManLongAtNI]

Hi mahii,

Please post any new issues to another thread. This question is better suited on the DAQ page.

You may want to include the type of ELVIS being used and type of example you are looking for.