cDAQ connection output should be ON without network

[Holas1505]

Hello,

i want my cDAQ output to be ON even if i unplug the network cable from my LabVIEW computer and again connect it.

Right now, what happening is my DAQ output is getting OFF when i unplug the Network cable from my computer, and it will restart if i connect the cable again.

I want it to be continuous ON even if my computer network cable in unplugged!!

Is it possible??

if yes then please let me know how to do it 

I

[GerdW]

Hi Holas,

---

@Holas1505 wrote:

I want it to be continuous ON even if my computer network cable in unplugged!!

Is it possible??

---

I guess the answer is found in the manual of your cDAQ and the module you use in this cDAQ chassis…

(You forgot to provide any specific information on your hardware!)

[Holas1505]

Hi GerdW,

My hardware's are cDAQ 9188 & cDAQ 9184 

In manual where i can see that?

Regards,

Holas

[GerdW]

Hi Holas,

---

@Holas1505 wrote:

My hardware's are cDAQ 9188 & cDAQ 9184 

---

These are two chassis, but no modules!

The chassis specs mention "Module IO states on power-up" as "depending on modules".

(When you disconnect the Ethernet communication the device probably goes to "power-up" state…)

Generic answer: when you need some "Safety" feature in your testbench then you should implement this using some hardware instead of relying on software features.