how to set the start and end point when i use integral in labview

[greenjuice]

Hello,

Using DAQ, I can integrate multiplication of two signals(ex) voltage signal * current signal)

But I want to set start and end point to integral so that I could target specific time interval.

Of course, I can know integral value between two points by seeing graph which show integrated signal

But I want to make a table of integral value between two points as two signals change.

My reference picture is one of my example.

Please let me know how to deal with it. Thank you!

[crossrulz]

Try using Array Subset to get an array containing only the samples you want.

[greenjuice]

But My signal has x - axis of time and y - axis of amplitude of signal.

When I extract initial array from graph, I can just get amplitude value, not time.

Given this situation, using array subset, then how can i extract specific value of specific time?

Can I get amplitude value with time value together, not just amplitude value?

[greenjuice]

For example, I want to get integral value of amplitude of signal between 0.02ms and 0.04ms.

[Yamaeda]

You should know or be able to extract the delta between each sample, then it's easy enough. 🙂 If you e.g. sample at 1kHz getting 0.02 to 0.04secs is 0.02*1000 through 0.04*1000 ==> sample 20 through 40.

/Y