labview code for flowmeter sensor

[sgirgin]

Hi all

I am using NI USB 6229 DAQ and Omega FTB-1302 flowmeter sensor.I made the proper wire connection.Now its time to labview coding but i dont know what to do.i am new in labview.Please help

Best regards

[aputman]

Look at some of the DAQmx examples in the Help...Find Examples.   Your sensor most likely outputs a 0-5V or a 4-20mA signal.  You can read those signals into Labview using the examples.  You will probably need to apply a scaling factor to get a meaningful value. 

[RavensFan]

Duplicate Post

[sgirgin]

It was about DAQ connection.This is coding

[RavensFan]

You've started several threads about flowmeter sensors and how to read them.  Stick with one of them.  You are basically asking the same questions about how to read them.