ruska 7000 driver conversion

[Otman]

Can someone convert this file from Version 5 (I believe) to Version 8.6?

I thank you an advance.

Otman

Message Edited by Otman on 09-14-2009 09:44 PM

[sppelletier]

Hello,

Why do you want to convert it? it work in 8.6.

[RavensFan · Accepted solution]

---

coolaid wrote:
Hello,

Why do you want to convert it? it work in 8.6.

---

How do you figure that?

VI's from that old of a LV version need to be opened in a bit newer version such as LV 7.1 through 8.5, in order to be opened up in either LV 8.6 or LV2009.

Try this llb in version 8.2.

[RavensFan]

Correction:

VI's from that old of a LV version need to be opened in a bit newer version such as LV 7.1 6.0 through 8.5 8.2, in order to be opened up in either [LV8.5],  LV 8.6, or LV2009.

I would recommend using either 7.1 or 8.2.

Here is the link to the version compatibility chart.

[sppelletier]

---

Ravens Fan wrote:

---

coolaid wrote:
Hello,

Why do you want to convert it? it work in 8.6.

---

How do you figure that?

VI's from that old of a LV version need to be opened in a bit newer version such as LV 7.1 through 8.5, in order to be opened up in either LV 8.6 or LV2009.

Try this llb in version 8.2 

Oups! Sorry about that. I had it in my user.lib and I was sure that it was working. Sorry.

[Peñata]

Hi Otman,

Here ya go. Mass compiled in LabVIEW 8.2.1. You should be able to open this in LabVIEW 8.6. Be aware that the VIs in the LLB may not function as expected if the functionality of any of the VIs changed from LabVIEW 5 to LabVIEW 8.6. This is simply to be able to open the VIs.

[RavensFan]

---

Dr. Horrible wrote:

Hi Otman,

Here ya go. Mass compiled in LabVIEW 8.2.1.

---

How is this different from what I posted yesterday in reply #4. ????

[Peñata]

Hi Ravens Fan,

Oops. Sorry, I didn't see that you had reposted the LLB.

Aaron Pena

National Instruments

Applications Engineer

http://www.ni.com/support

[Otman]

Thank you all who responded. Your help is so kindly appreciated.

[hugomeshg]

Hi,
I looking for the driver for the RUSKA 7615. This driver will work in my equipment? Do I need to convert to Labiview 17?

I intend to measure the pressure and save the datas.

Regards