i have a project about the automatisation of oven , and i have udc 1200, so i want to interface the udc1200 with labview ,in order to control the temperature of the oven.
There does not seem to be any available premade drivers to communicate to this device. The best way to accomplish this would be to use VISA commands via LabVIEW. Please refer to the following link for some general information on NI VISA and how to get started
but the big problem is how to programming udc1200 to connect with the pc by the serial communication rs485, i read all data of the controller but i didn't any thing about that , just configuring the slot A as rs485 when OPENA=ENABLE, but i don't knew how , can you help me!!
