The version of the LabVIEW NI SoftMotion Module installed on the host differs from the version installed on the RT target.

[Eng.Tareq]

SolidWroks design

[TuiTui]

Hi Eng.Tareq

Did you follow this step in order to create your application?

http://www.ni.com/white-paper/9566/en/#toc6

Best regards,

TuiTui

[Eng.Tareq]

hi
yes i followed but i donno what is the problem

[TuiTui]

Hi Eng.Tareq

By looking at the document and what you are trying to do, You should be at step 4 

Step 4: Deploying to Hardware (Optional)

Is this correct?

If this is the case, in the document there is a part written

The following additional hardware and software is required to complete the "Step 4: Deploying to Hardware (Optional)" section of this tutorial:

Software

• LabVIEW Real-Time Module 2009 or later 

• NI-RIO 3.2.0 or later

Hardware

• NI CompactRIO controller and chassis that support the RIO Scan Interface
  or
• NI 9144 distributed chassis

• Two NI 9512 single-axis stepper drive interfaces

• Power supply for the controller

• A separate power supply for the modules

• Ethernet connection and cable

Even if you do not have the hardware used in this tutorial, you can follow the steps and perform offline configuration to learn about using CompactRIO with LabVIEW. 

By look at the list of your software, I don't think you pass all the requiement

1.I don't see NI RIO in your list of software

2. Do you have labview Real-Time Module installed?

Best regards,

TuiTui

[Eng.Tareq]

but i dont have any hardware
i just want to connest to solidworks

[TuiTui]

Hi Eng.Tareq,

Can you tell me which step are you upto?

And what have you done that the error shown up?

TuiTui

[Eng.Tareq]

i added Solidworks model and axis
i want to deploy the project after this i got this message
thanks

[TuiTui]

Hi Eng.Tareq,

Adding the model and axis is in step 1 of this paper http://www.ni.com/white-paper/9566/en/#toc6

Have you do the configuration and create a motion profile which is step 2 and 3 in the paper

If you have done all the thing in that paper, can you post the VI so that i can investigate?

Best regards,

TuiTui 

[TuiTui]

Hi Eng.Tareq

How is the thing so far?

TuiTui