NI9237 calibration in MAX

[ruud_unibw]

Hello,

I try to calibrate my strain gages.

My set-up is as follows:

- strain gage

- NI9945

- RJ50 cable

- NI9237

- cRIO9024 (DAQmx driver is installed, see Figure 1)

and LabVIEW 2014 installed

I would like to start with a calibration in MAX as described in: http://www.ni.com/tutorial/7130/en/

Unfortunately I am not able to create an "NI-DAQmx Global Virtual Channel"... (see Figure 2, 3)

At the same time I have programmed the FPGA to gather data with the NI9237.

This works without any problem and thus the connection, the cRIO, the module are fine. It shoud be kind of a driver-issue..?!?

Thanks for the help in advance,

Ruud

[Dennis_Knutson]

A cRIO does not use DAQmx. It uses the FPGA code as you apparently have already done.

[ruud_unibw]

owww fair enough, so I need either

- a compactDAQ system, or

- a Ethernet C-Series cDAQ Module carrier (e.g. ENET-9163)  ..?

Thanks a lot Dennis,

All the Best,

Ruud