OMRON E5CC,error S.ERR after adjust

[korbw]

Hello everyone,my problem is related to Digital Temperature Control OMRON E5CC,at my workplace I had some problems with one of the furnaces I wanted to fix,I wanted to correct against another device that we check the temperatures and too much zeal in the protected area, but I did not give up, I passed passwords (cmoV with password 1201) I reached adj 30, where I followed the steps and I managed to decalibrate it.Now I'd be glad if I could get to the factory settings.use a temperature sensor type J (-200 to 1300),today I will try with a PT100 sensor.I would like to get some advice or opinion about on how to recover the Omron device. Thank you in advance.

[ARVega]

Hello Korbw, 

Your question does not really address a specific NI product, hardware or software, could you let us know if you are using or need specific help with any NI product? Also, here is a forum post related to your device:

https://forums.ni.com/t5/LabVIEW/Omron-E5CC-Temp-Controller-Modbus-Reading-Registers/td-p/3610919

Perhaps this post can be helpful.