Multifunction DAQ

cancel
Showing results for 
Search instead for 
Did you mean: 

compatibilità cDAQ9178 e cDAQ9188

Hi,

Can I connect and synchronize these two cDAQ? cDAQ9188 and cDAQ9178 with the bnc cable?

 

0 Kudos
Message 1 of 2
(3,285 Views)

You can use the two BNC terminals on each cDAQ to input or output timing signals for all task types.  That means you can share a clock and a trigger from one of the chassis to the other, so you can synchronize any tasks that would use those shared timing signals.

 

* Note that the chassis PFI lines support a maximum input or output frequency of 1 MHz, so you will not be able to share a timebase or a clock with higher than 1 MHz frequency between the chassis through those terminals.  In order to share higher frequency timing signals, you would need to use module PFI lines (on a DIO module installed in the chassis) or the NI 9469 chassis synchronization module.

0 Kudos
Message 2 of 2
(3,268 Views)