drivers for NI-DAQmx Simulated Devices (NI9211 etc) in cDAQ9174

[NCLbingji]

I am trying to understand the three methods of calculating the maximum analog input sampling rate of an NI CompactDAQ system as stated below

http://zone.ni.com/devzone/cda/tut/p/id/4320

Problem 1

In method 1. Build your physical hardware system or simulate your configuration in Measurement & Automation Explorer (MAX) using NI-DAQmx Simulated Devices

Buy using my MAX, I was able to build a simulated chassis NI cDAQ7192, however the modules NI 9233, NI 9215 and NI 9211 can not be found in the MAX. Do I need special drives for them?

My MAX is verson 4.6.2f1 and LABVIEW2009.

Problem 2

Following the Method 2 to use the NI CompactDAQ Advisor, 'Calculate analog input performance' is not shown up after configuring the chasis.

Thanks a lot for all your help

Regards

Bing

[Dennis_Knutson · Accepted solution]

Your version of MAX and LabVIEW is irrelevant. what is your version of DAQmx?

After adding the chassis, did you right click on it to select 'Configure Simulated cDAQ Chassis'? I did that and was able to select all of the devices you mentioned.