Error message when formatting cRIO 9067 disk

[Ivan01]

Hello comunity, I have a cRIO 9067 and I would like to communicate with LabView. When I connect it to the PC, MAX detects it in safe mode (no software installed).

I use the 2021 version of LabView, so I have already installed the Real Time, FPGA modules, and the Linux RT system image 21.5 as well as NI Linux Real-Time Offline Instalation Support 21.5, but when I try to install the software on the cRIO I get the following error "System failed to restart after the hard drive was formatted".

What could be happening? 

[altenbach]

Continued here