OMICRON 256+ configure V-Fault

[Marinuss]

Hello

I created a short test, only to test communication with OMICRON 256. See Capture.PNG

I can see that the Init CMC connection step pass gets done with no errors when I open it in Labview and run with lightbulb.

But when the COnfigure CMC VFault step is done, then I get an error. See Error.PNG

What might be the problem? Help will be appreciated.

Teststand: 2016 SP1

Labview 2016

Marinus

[Marinuss]

Thank you people 

I found the problem. I didn't specify the VIs in and Out variables.

Marinus

[Prashant1991]

Can you say which instrument Library you used is it with ActiveX control (Test universe)or direct communication with instrument