03-01-2022 08:39 PM
Hi Everyone,
I'm facing an issue that occurs a alert message "Error code:- 17338 "about Teststand opening a sequence.As shown in the figure below:
So I how to solve this issue?
03-01-2022 09:40 PM
"Config DAQ" step uses a LabVIEW VI developed in LV2013 and unfortunately the version of TestStand you use can only support LV 2017 SP1 or later.
Solution - open the VI used in the "Config DAQ" step, recompile to LV2017 SP1 or later.
05-13-2022 03:37 AM
I also receive:
“TestStand cannot locate a LabVIEW Run-Time Engine of version '11.0' and bitness '32-bit'.”
-17388, LabVIEW runtime DLL (lvrt.dll) is not loaded.
Suche: geht nicht hier. Manuell: TS_Err_LVRTDllNotLoaded–(Value: -17338)
LV2020SP1, activated (evaluation), so editor works
TS2021SP1 (newest), activated (evaluation).
I do not think that LV2011 is ment and needed.
Version LV and TS are compatible.
What have I to do to solve this issue?
Thank you
05-16-2022 01:20 PM
Do you have any steps that call a VI compiled in LV2011? if yes, please recompile them to LV2020 to resolve the error.