Rif.: VeriStand FPGA XML Builder Node Feedback

[semarcorra]

Hello everyone, 

I am trying to use the FPGA XML Builder Node. I am experiencing a problem that someone already mentioned previously in this discussion. 

After the installation, when I try to put the node on the block diagram, LV automatically looks for some .dll files that are missing. I cannot proceed. 

Some of you solved this issue simply by copying the config file in the same folder of the labview.exe (as stated in the instructions) but i already did this step and it was not successful. 

Maybe the problem is that I have LV2020, but among the downloadable zips ( https://forums.ni.com/t5/NI-VeriStand-Add-Ons-Documents/NI-VeriStand-Add-On-FPGA-XML-Builder-Node/ta... ) the 2020 config file is not present, so I am trying with the 2019 version. 

If I am correct, could someone please send me the correct 2020 version of the config file? Any help would be appreciated. 

Thank you, 

Marco S.

[Pianne]

Hi Marco,

Maybe you can try editing the config file yourself, it seems that all it does is redirect from an old version to a new version...

<bindingRedirect oldVersion="2013.1.0.0" newVersion="7.0.0.0" />

In this case, "7.0.0.0" is for LabVIEW 2019. Try changing to your LV version and see what happens... 🙂

PJ

[semarcorra]

Hello Pianne, 

Thank you very much, it worked. Cheers!

[Paolo_Squillari]

Dear all,

 I'm absolutely new to VeriStand..

I'm using the "VeriStand FPGA XML Builder Node" in order to:

• read AI values from an NI 9215
• write AO values to NI 9263

I had no problem in reading the AI voltages from NI 9215, but I can't update the AO voltages...

I've written this code for the FPGA:

(in order to test the "VeriStand FPGA XML Builder Node" I also added the possibility to switch on/off the FPGA LED).

I've generated the XML file, compiled the FPGA and imported both files in VS 2018.

I had no problem with the VS import:

When I try to update the AO (Mod4/AO0) or the FPGA-LED nothing happen.

Voltage is 0 and the FPGA-LED is OFF.

If I connect a constant to the FPGA-LED (constant=1) the LED turn on when I run the VS project, so the LED works.

Thank you for your help.

Paolo.