Current and voltage trasformer

[McTALAO]

Hello to all,
I'm developing a system of power analysis based on "Electrical Power Measurement Toolkit".

I think to use a system based a cRIO-9075 and a NI 9215 (simultaneous sampling).

I think to use this current and voltage trasformers:

• http://www.magnelab.com/products/Current-Voltage-Sensors/solid-core-ac-current-sensor-uct-0300-
• http://www.magnelab.com/products/Current-Voltage-Sensors/potential-voltage-current-transformers--spt...

The voltage range in output from these sensors (0 - 333.mV) disagrees with that of the acquisition module (0 - 10 V).

There might be a problem of signal levels? In this case, can you tell me how to adapt the signal?
Any other configurations are welcome.

Thank you very much,

Federico.

[Padeanu.L]

There is no problem, the NI 9215 has a minimum voltage acurracy of 0.003 V........just set the measuring range of the Daq card in DAQ asistan from 0-10 V ....to 0-1 V.

Have a nice day!