Hi,
I installed labview NXG 5 with NI USRP 2930 and trying to run TX continuous async and RX continuous async programs from examples. But I am having 9 errors in tx program most of them are related to missing dependency (attached).
The basic functionalities of tx module – close session, write tx data (CDB), configure signal and open tx session – all are missing. I have installed NI USRP drivers by following the getting started guide of NI USRP. I have seen that other users are having same problem in this ni forum but no solution is given there:
https://forums.ni.com/t5/USRP-Software-Radio/Missing-dependency-NI-USRP-niUSRP-udr-niUSRPClass/td-p/...
There are some wiring related errors too besides the missing dependency error. I am new with both Labview and USRP and cannot figure out what's going on. Can anyone please help on finding out why these errors are occurring and how to resolve them? Thanks in advance.
Md Zobaer Islam
PhD Student, Electrical Engineering
Oklahoma State Unviersity
