Can't connect to cRIO 9074 in MAX

[Raposo]

I can't connect to a cRIO-9074, using MAX (LabVIEW2016).

What happened before: Adding software to cRIO with MAX, Cable disconnected during the process, Format

Now, Console Out shows IP 0.0.0.0.

How to connect, using MAX?

Note: The FPGA application is working (USER1 LED flashes as programmed)

[s_ipour]

Hi,

Thank you for posting on the NI Forum.

Can you have a look at the following article that might solve your issue : http://digital.ni.com/public.nsf/allkb/ABE4BC247E8AC9BC8625734E005CAB42

Best Regards

[Raposo]

Thank you, s_ipour.

I still can't connect.

MAX Troubleshoot Remote System Discovery crashes (attached pictures).

I can't ping IP 0.0.0.0.

Do you have any suggestion?

Best regards.

[etuzuner]

Hi raposo, 

I think information at page 10 of this manual may help you.

Emre

[Raposo]

Hi, etuzuner.

Thank you, but I still didn't solve the problem.

The part number begins with 192172.

Console out shows the IP address is 0.0.0.0.

MAX still doesn't see the cRIO.

Console Out shows "Cannot open "/c/ni-rt/system/vxWorks".

Is this OK? (I formatted the cRIO)

Pedro

[natasftw]

What's the current setting for your dipswitches?

[etuzuner]

Hi Pedro, 

natasflw is right, can you tell us DIP switch configuration? Proper position should be told in the manual. 

Emre

[Raposo]

Hi,

At the moment, all DIP swtiches are ON, except "USER1".

The problem started after formating the cRIO (IP 0.0.0.0).

I could connect before.

I could connect to an identical cRIO, after the problem. So, I am sure the problem is not on my laptop/virtual machine.

I was "forced" to format the cRIO, after a power loss when performing "Add Software". Can this harm the cRIO?