Home Community Discussion Forums Most Active Software Boards LabVIEW Topic

LabVIEW

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Connection of Rexroth linear motor (and drive) to LabView for changing parameters (velocity, torque, ...) to test peformance of nano-generator.

Connection of Rexroth linear motor (and drive) to LabView for changing parameters (velocity, torque, ...) to test peformance of nano-generator.

‎06-27-2024 07:42 AM

I would like to know if it is possible to connect (directly or indirectly) a 3-phase synchronous pm-motor from Rexroth to LabView and then tune/configure/program and/or change its parameters using LabView. The goal is to connect the motor/drive to LabView, directly or indirectly, so that I can toogle with the motors' parameters (velocity, torque, frequency, etc), in order to see the consequences in the performance of a triboelectric nano-generator. The final goal is to use the system to test a wave energy harvesting system.

0 Kudos
Message 1 of 2
(172 Views)
Reply

Re: Connection of Rexroth linear motor (and drive) to LabView for changing parameters (velocity, torque, ...) to test peformance of nano-generator.

‎06-27-2024 09:31 AM

Please share the link to your motor/controller. In general, if it has some communication port like USB, RS232 or sort to connect to a PLC or a computer, then probably yes, you could control it in LabVIEW. To answer which extent it is controllable depends on what features are exposed to be adjusted over the communication port.

 

Santhosh
Soliton Technologies

New to the forum? Please read community guidelines and how to ask smart questions

Only two ways to appreciate someone who spent their free time to reply/answer your question - give them Kudos or mark their reply as the answer/solution.

Finding it hard to source NI hardware? Try NI Trading Post
Message 2 of 2
(150 Views)
Reply