HELP -FPGA SPARTAN 3E-100 CP132 WORKS WITH LABVIEW FPGA ?

[dvaldez2]

HI EVERYBODY, IM TRYING TO USE MY FPGA BOARD WITH LABVIEW, BUT I DONT KNOW THAT IF ITS COMPATIBLE, I INSTALLED DRIVERS, FPGA MODULE, AND LABVIEW 2012, IM USING WINDOWS 7 32 BITS, AND AFTER I COMPILE ITS SAID :

LabVIEW FPGA called another software component, and that component returned the following error:

Error Code: -310601

NI-COBS:  Unable to detect communication cable.
Please verify that the communication cable is plugged securely into your computer and target. Also verify that the appropriate drivers are installed.

THANK YOU .

😃

[Alhern · Accepted solution]

Hi dvaldez2.

LabVIEW FPGA does not offer support for any third party hardware, other than the Spartan 3E XUP Starter Kit. Those are probably the drivers you downloaded.

http://digital.ni.com/express.nsf/bycode/spartan3e?opendocument&lang=en&node=seminar_US

However, this driver only supports the Starter Kit board itself (http://www.digilentinc.com/Products/Detail.cfm?NavPath=2,400,790&Prod=S3EBOARD). You can't use the driver with any other FPGA from Xilinx.

Hope this helps.

[dvaldez2]

thank you very much Aldo,

and for your time,  😃

regards

David Valdez 🙂