Beginner at LabView, Load Cell Force Measurement?

[ragusakthivel]

sir how to connect the beam type load cell of 1 kg and same that excidion voltage 5V and how to interface the mydaq device plz explain this is my problem 

[paulrobinson]

Hi Ragu,

   It depends on type of daq which you are using and also the signal conditioner to amplify te signal from sensor, anyway what type of daq you're using?

Regards,

Paul robinson

[ragusakthivel · Accepted solution]

actually i am using only my daq, it is useful or not , because i am already  cheack the  my daq  reading was not get aqurately so which eqipment is best result output for loadcell (beam type 1kg) measurement using labview .. please explain me sir 

[majoris]

The myDAQ has an analog input with a range of +/-10V. That seems to be plenty for your application with a maximum voltage of 5V.

I don't see where you describe the setup or the exact problem you are having. What have you done, what does it do it, and what do you expect?