Rif.: CVI Real Time and standalone cDAQ

[vix]

Can CVI Real Time be used to develop and remotely debug application running on a standalone cDAQ (9132, 9133, 9134, 9135, 9136, 9137) when they run NI Linux Real Time?

I found this document, but it's old (before the release of standalone cDAQs) and I don't understand if CVI RT supports them or not.

[LiciaP]

Hi Vix,

unfortunately CVI Real-Time supports only Pharlap for now (see also help), thus the only stand-alone cDAQ controllers supported are the Pharlap ETS ones (cDAQ-9138 and 9139).

Linux RT is not actually supported by CVI Real Time.

There are plans to include this support in the future but apparently this might not be immediate.

I hope this helps!

Bye,

Licia

[vix]

Bad news...

I see that cDAQ-9138 and 9139 are legacy products and so I don't think it's a good idea using them for a new project.

Can you share the NI roadmap for this support, please?

I need to know if I can consider them for a new project.

[LiciaP · Accepted solution]

Hi Vix,

unfortunately I have no official or precise information but unfortunately the CVI Linux RT integration project will be quite far out in the future (not in the upcoming years).

Bye

Licia

[vix]

I added this new suggestion in the Idea Exchange Forum (even if it's not clear if the forum is actively considered by NI - in the past it was)