Error-201003 occured at DAQ Assistant

GuGuGooo · ‎08-18-2016

Hello. I'm using "cDAQ-9178" and "NI 9215" and "NI 9402" are added on.

However, when I run a Labview code, "Error-201003" occurs.

{

Device cannot be accessed. Possible causes:

Device is no longer present in the system / Device is not powered /

Device is powered, but was temporarily without power / Device is damaged

}

(Error is shown like the 1st and the 2nd figures below.)

(Sheme of the logic is in the figure below.)

Thank you.

stockson · ‎08-18-2016

Hi keuntae,

did you try resetting the device or running a self test?

GuGuGooo · ‎08-18-2016

Yes. I'm afraid that I already did that.

stockson · ‎08-18-2016

And what happens? Do you get the same error?

niarena · ‎08-18-2016

I could be something with the driver

check this:

Error 201003 at Test Panel in MAX or While Running DAQ Assistant

In this forum, they talk about the same error:

Spontaneous Error Code 201003 for PCI DAQ Setup

niarena · ‎08-18-2016

make sure DAQmx version you got is compatible with the Labview you are using, check the readme file of that version of the driver

Multifunction DAQ