Error-201003 occured at DAQ Assistant

[GuGuGooo]

Hello. I'm using "cDAQ-9178" and "NI 9215" and "NI 9402" are added on.

However, when I run a Labview code, "Error-201003" occurs.

{

Device cannot be accessed. Possible causes:

Device is no longer present in the system  /  Device is not powered  /  

Device is powered, but was temporarily without power  /  Device is damaged

}

(Error is shown like the 1st and the 2nd figures below.)

(Sheme of the logic is in the figure below.)

Thank you.

[stockson]

Hi keuntae,

did you try resetting the device or running a self test?

[GuGuGooo]

Yes. I'm afraid that I already did that.

[stockson]

And what happens? Do you get the same error?

[niarena · Accepted solution]

I could be something with the driver

check this:

Error 201003 at Test Panel in MAX or While Running DAQ Assistant

http://digital.ni.com/public.nsf/allkb/5413F392D88326148625746B006745C5

In this forum, they talk about the same error:

Spontaneous Error Code 201003 for PCI DAQ Setup

http://forums.ni.com/t5/SignalExpress/Spontaneous-Error-Code-201003-for-PCI-DAQ-Setup/td-p/830707

[niarena]

make sure DAQmx version you got is compatible with the Labview you are using, check the readme file of that version of the driver