oscillator

[supsup]

Yes, this circuit is correct. However, if you work with Bode Plotter, the frequency metre is not necessary.

[dwuihf]

I have multisim 11 registered virsion.i want to show my output waveform on the Grapher. i dont have the grapher!!

how can i add it to my toolbar?

thanks

[supsup]

main menu View>>Grapher

[dwuihf]

the graphic is not in my main menu view.. how can can i include it to the list?

[dwuihf]

the graphic is not in my main menu view.. how can can i include it to the list?

[supsup]

See Multisim Help:

Commands tab

Use the Commands tab in the Customize dialog box to add commands to menus and toolbars.

Complete the following steps to add a command to a menu or toolbar:

1.Make a selection in the Categories list.
2.Drag the desired command from the Commands list to the desired menu or toolbar. When a command is selected in the Command list, its description is displayed in the Description field.
3.Click Close when customizations are complete.
To remove a command from a menu or toolbar, right-click on it and select Delete from the context-sensitive menu that appears. The Customize dialog box must be open when you do this.

To change the position of a command that is in a menu or toolbar, drag it to its new location. The Customize dialog box must be open when you do this.

[dwuihf]

i got it. thanks

[dwuihf]

 what is the difference in oscillation wave at point X and at point Y?

for my knowledge, the diodes block the distortion that caused by OP amp and if i show the waves at node X, that means i am showing distorted waves,but i did not see this in both circuit. both circuit showing exactly same waves with same amplitude and non distorted even if i bypass the diodes!!!!

kindly, i need advice and explanation.