array out parameter from labview

[renek]

Hello,

i want to join UInt8 arrays (MSB/LSB) to a UInt16 array.

If i run this in LabView is no Problem.

But when i call from TestStand, there is no Out Parameter filled.

After i run the Teststep there are no Values in the Locals.MSBLSB Array. Is there any Parameter i had to set that LabView can write into the Locals.MSBLSB Array?

Regard,

René

[RayFarmer · Accepted solution]

So what values have you got in the two arrays locals.lsb and locals.msb because if these are empty arrays then you will not get any output?

Regards
Ray Farmer

[renek]

Hi,

i make a mistake. I look to the out Array after the Test is running. After i set a Breakpoint i see the Values during testing.

Thanks for the answer