10-05-2024 07:05 PM
Recently been having some issues with the RIO2 not being reached (no RSL, orange blinking status light). It seems to return to working (three times so far). Today I tried to carefully remove any possible metal swarf, it normally has most ports taped over to keep this minimal. There wasn't an obvious issue.
We are getting ready for an offseason and not with with a backup. So if this latest effort resolves the issue for longer, we should be okay, but may want the look further if it returns. I wanted to make a topic to track this issue further.
Solved! Go to Solution.
10-08-2024 12:04 PM
Hi nelson.green,
I'm stevezuga from NI Tech Support. I'm glad to assist you.
A continuously flashing Status LED in the roboRIO 2.0 normally indicates the device cannot boot properly, likely because the SD card is not being read.
I recommend you the following steps:
Sincerely,
10-16-2024 11:50 AM
Thanks Steve,
I completed steps 1-4. There was some swarf inside the case, removed mostly with air and going over carefully. The microSD card slot was clean, it had been taped over since the last imaging at the start of the year. It has recovered 2-3 times after stopping working so far, and was working after these steps. It was I think possibly working before re-imaging the card and certainly after imaging but before cleaning the insides. I will let you know if we have faults going forward, but hopefully whatever issue there was was fixed.
10-22-2024 12:01 PM
Update: So far haven't seen the error return. We finished 12 matches at an offseason without issue. Thanks.