Worksheet corrupting areas

[Craig123]

I'm not sure how to explain this, but I am creating a new project and have been adding, deleting, and moving Modules in my Worksheet.  Now I have areas in my worksheet that act like there is something in that spot and will not allow a connection (wire) to run through the spot or allow a module to move to that spot.  Is there a way to clean up a worksheet?  At one time my project got locked up and would not respond and I had to have Windows shut it down.  This could have also caused the problem.  Any ideas on how to fix this?  I'm using DasyLab 13.0.

Thanks

[CJ_Butler__DASYLab_Pro]

Stop. Close DASYLab. 

Send me the worksheet. cj.butler@ni.com

[MD_ELECTRONIC]

Hi Craig,

I have sometimes the same problem...

Try this:

-save your corruted worsheet in .DSA format

-open the .DSA worksheet and save it in .DSB format

The new .DSB worksheet should be "clean"...

[Craig123]

Thanks for the tip.  I can try that if it happens again.  CJ already fixed it for me this time.

[MD_ELECTRONIC]

Ok Craig, you're welcome!

And how CJ fixed this problem???

[CJ_Butler__DASYLab_Pro]

Just to close this out.... in some cases, I can repair corrupted worksheets. 

Contact me via email or private message with a copy of the worksheet.

[iglesiase]

Can anyone provide a solution to this issue? I attempted the (DSB to DSA to DSB solution and I still have the area corruption in my workspace.

[MYMTEST]

Hi,

I have been same problems with some worksheet. It would be nice if someone would have solution for that.

br Mika