09-28-2022 06:49 AM
Hi all, I have a few lessons in my LabVIEW Core 1 training that won't complete. I've gone through all of them, but on the course page, they say "continue" and not "view" (completed). Anyone know how to get them to complete? Thanks!
11-18-2022 07:51 AM
Hello nicktherushfan2
The post is quite old, and I hope there is not any problem anymore, but if it still exists, you can contact Education NI by clacking contact us in Course installation page. I have attached links below.
Also consider on videos in the course that you should watch them fully and after that move to the next one. So, what I suggest you double-check it in detail and after that if there will be problems yet, contact from pages and report that issue.
Regards)
12-19-2023 10:48 AM
Just going to say this issue still exists and as much as I like rewatching videos I've already watched; I don't have time for this.
12-19-2023 02:51 PM
I can also confirm this is still a problem. I sometimes have to go back and "watch" the last slide a few times before the lesson will show up completed.
12-19-2023 05:26 PM
This doesn't help, but I think it's more of a problem with the lesson software than with anything NI can help with. I've seen this before with learning software in general. I've learned that you should always watch the videos until they end.
12-21-2023 10:00 AM
Go to the three lines box(navigation menu) in the left top. check whether you have ticks on all of them. If not wait for few seconds or play the videos. Then check it solved.
01-15-2024 04:10 AM
Hi!
This problem is still exist but I think I solved it. You just have to stay at the very last slide for like 5 seconds and after it will be marked as done 100%.