LabVIEW Core 1 Lesson Completion Problem

[nicktherushfan2112]

Hi all, I have a few lessons in my LabVIEW Core 1 training that won't complete. I've gone through all of them, but on the course page, they say "continue" and not "view" (completed). Anyone know how to get them to complete? Thanks!

[l.hovs]

Hello nicktherushfan2112, 

The post is quite old, and I hope there is not any problem anymore, but if it still exists, you can contact Education NI by clacking contact us in Course installation page. I have attached links below. 

LabVIEW Core 1 Course - NI

Contact Us - NI

Also consider on videos in the course that you should watch them fully and after that move to the next one. So, what I suggest you double-check it in detail and after that if there will be problems yet, contact from pages and report that issue. 

Regards)

[nimig32]

Just going to say this issue still exists and as much as I like rewatching videos I've already watched; I don't have time for this. 

[Lavezza]

I can also confirm this is still a problem. I sometimes have to go back and "watch" the last slide a few times before the lesson will show up completed.

[billko]

This doesn't help, but I think it's more of a problem with the lesson software than with anything NI can help with.  I've seen this before with learning software in general.  I've learned that you should always watch the videos until they end.

[RepMat]

Go to the three lines box(navigation menu) in the left top. check whether you have ticks on all of them. If not wait for few seconds or play the videos. Then check it solved.

[tamas_guruczi]

Hi!

This problem is still exist but I think I solved it. You just have to stay at the very last slide for like 5 seconds and after it will be marked as done 100%.