Ports not showing up - NI 9482

[eLAB_RAT]

I am making a program that can remotely switch ports on and off for the NI 9482 module. My issue is that the DAQ Assistant only recognizes port 0 and its four channels. 

I am able to remotely switch port 0 using LabVIEW but I also need to be able to switch port 1.

Is there any setting I can change that allows me to view and use other ports?

Thank you.

      

  

[ZYOng]

Program C Series Relay Output Module with DAQmx

• A port output uses one channel for all lines.
• A line output uses one channel for each line.

[eLAB_RAT]

For my program I need to be able to access line 1-4 for ports 0 and 1. I notice only lines for port 0 are showing up for you, and that is the same issue I have. Is there a way to access line outputs for port 1?

[GerdW]

Hi RAT,

---

@eLAB_RAT wrote:

For my program I need to be able to access line 1-4 for ports 0 and 1. I notice only lines for port 0 are showing up for you, and that is the same issue I have. Is there a way to access line outputs for port 1?

---

Which "port1" are you talking about?

The NI9482 is a 4 channel DO module, so you get 4 lines in one port as shown in the images above!

General recommendation: read the manual… 😄

[LVNinja]

this module NI 8482 has only 4 lines, on port 0. there is no port 1. 

When you write "1" on the  line 0 the module closes the connection between CH0a with CH0b.

[LVNinja]

This module does not have port 1.